groupdiy.com
The design caters for three alternative microphone transformers by Sowter, Jensen and Cinemag, The mixer will be built with two channels using Sowter transformers and one each using the Cinemag and Jensen types. The design also supports a 3 band Pultec style EQ or one modelled on the Helios Type 69. Two channels with have the Pultec EQ and the other two will have the Helios EQ.
Each channel will have:
- Switches for phantom power, phase, 20dB pad and mic/line selection
- 12 position stepped gain control covering a gain range from 60dB downwards in 3dB steps
- Smart Pan (pan control only selected when both left and right buses are selected)
- AUX send switchable pre or post fader
- Pultec or Helios 3 band EQ with EQ in/out switch
- Rotary channel fader
- Direct out
Channel PCBs fit into a 6U high 14HP wide standard Eurocard slot.
Six channels will fit across a standard 19 inch sub-rack. In this mixer four channels are used for inputs and the other two for the master section. The sub-rack is fitted with a backplane into which the channel PCBs are plugged using a 32 way 0.2inch pitch connector.
The master section will contain:
- Master rotary fader
- Master AUX send fader
- AUX return with Smart Pan
- Monitor selection and level control
- VU meters
The mixer will be housed in an off the shelf enclosure made by Rackz
They make a very nice sloping 19 inch rack enclosure with an add-on meter bridge.
You can see where the two VU meters have been mounted in the bridge. A standard 6U high sub-rack which which house the channels and master section is fitted into the sloping front panel of the Rackz enclosure. The sloping area is 8U high which leaves a 2U space below the channels sub-rack for rotary faders and a scribble strip.
The picture above does not really show the sloping front so here is one that does!
I just ordered the sub-rack that will house the channel modules. I ordered this from SRS in the UK because, although sub-racks are available at similar prices from distributors, you cannot buy all the little bits and pieces needed to customise the sub-rack. With SRS you just phone up, tell them what you want and they email you a quote. In this case I have four channel modules each 6U high and 28HP wide which together use up two thirds of the width of the sub-rack. In the remaining third I want to have the mix amps, AUX send masters, AUX returns and monitor selection and level controls. The mix amps and AUX sends only need to be 3U high so I want to put them at the top of the remaining third so they plug into the backplane. Below these I want to have a panel containing the monitor section. So I need a little bit of mechanical wizardry that divides the 6U high space into two 3U high spaces and that's where SRS really comes into its own - their guys know just what parts you need to do this. I also want to fully screen the sub rack so I need top and bottom vented screens and again SRS know what I need. Their MOQ is only 100GBP which a custom sub-rack like this easily exceeds so you get just what you need with no penalties for being a small order. Check them out srs-products.co.uk
Thanks for putting this up! Very interesting. It also looks really expensive. Hope it turns out well.
ReplyDelete